Home /
NEWS /
How to build chain link fence
Jun 06, 2018
How to build chain link fence ,many clients have such questions ,now i will teach you how to build it.
In fact, the installation of chain link is very simple, pre-buried fence net, when installation, first from the starting point digging pit, the first starting point of the post put well, remember not pouring cement, brick masking the column does not fall on the line, the rest and then turn out, a net piece of a column so all with screws, and then the end of the column with the end of the other side.
At the upright post that has been established, the upper and lower screw holes are straight, and then the location of the column is seen, the mark is drawn, the net is taken and the hole is opened, the hole is put in, the screw holes are put on the side and the screws are put on the top, and the post has just been put on the brick. Down, every 5 pieces of mesh with bamboo rod or stick support, prevent to drop, all good, then cast cement, when the cement is not dry, one person is responsible to see, one person is responsible for adjusting the angle, such as the cement dry fence will not appear in the situation if it is difficult, we can also be responsible for installation. The highest height can be achieved four meters.
The general specification of the cross bar is the diameter of five cm and the thickness of the wall two mm round pipe; the column uses a diameter of six cm and a wall thickness of 2 mm round pipe.
This is only a general specification, and customers can specify the size according to their actual conditions. Under the condition that the production conditions of the fence are permitted, production is made according to the requirements of customers.
The barrier net processing treatment first hot galvanizing is to prevent rust, hot galvanizing is to remove the work piece oil, acid washing, dipping, drying after melting into the molten zinc solution for a certain time, it can be put out. The appearance of hot-dip galvanizing is slightly coarser than electro-galvanizing, silver white, and the appearance is easy to produce water marks and a few drops of tumor, especially one end of the work-piece is more obvious. However, the zinc coating of hot dip galvanizing is several times thicker than that of zinc electroplating, and its corrosion resistance is strong. It is more than ten times of zinc plating. Because the plastic product thickness is thin, the spray plastic can only be 0.2mm, so it must be hot galvanized before the spray can ensure the quality of the good, so that the product service life longer.
Pre：Double wire fence for sale
Next：Colorful chain link fence for widely application
Address
.png)
.png)
.png)
.png)
