Double Wire Mesh Fence installation method

Double Wire Mesh Fence installation method / step one: Set the distance from the pit to the pit: According to the length of the column to the column, if the size of the guardrail is 1.8 × 3 meters, then the distance from the pit to the pit is 3 meters.

The midpoint of all pits can be marked with a tape measure.

Two: Digging: Generally speaking, if it is not a special high or special required guardrail, we usually pre-bury 30 cm, you can dig a 30X25X25cm pit.

Three: Place the column, fill or concrete: In order to prevent the column from being skewed, the column can be supported by the fixture. At this time, the position of the column to the column can be measured again. If not, the column can be fine-tuned.

If it is to make the guardrail stronger, you can fill the concrete in the pit. After the concrete has dried out, the mesh is installed.

Four: Install the mesh: Determine the position of the mesh. If it is 10 cm from the ground, you can make a mark on the column. Then align the ears on the column with the double wires at the edge of the mesh and secure with screws.